How to fit your save-a-flush

Save-a-Flush instructions

Please note: The save-a-flush won’t fit in dual flush toilets, or toilets installed after 2000.

First of all, squeeze the save-a-flush to make sure all the air is removed.

Then, lower the save-a-flush down into the bottom corner of the toilet cistern. Hold immersed for a few seconds then flush the toilet allowing the device to sink.

Make sure the save-a-flush is towards the front of the cistern, between the ball valve and the front panel.

Allow about six hours for the save-a-flush to expand to full capacity and check the ball valve and overflow are not obstructed. If your toilet stops flushing properly please remove the save-a-flush from your cistern and dispose of in the household rubbish.

Email this page